I’m getting high frequency noise in the form of “pops” while recording from apps to Auria Pro via Audiobus. I’ve tried 3 different apps using a beat or synth part that I’ve already created in-app then played back to record to Auria. I’m working on an Air2 and I have no other apps open during playback/recording.
Any thoughts on what would cause that?
Signal “pops” during recording
-
- New Member
- Posts: 1
- Joined: Sat Sep 07, 2019 10:54 am
- Anthony Alves
- Expert
- Posts: 1444
- Joined: Sat Mar 10, 2012 9:52 am
Re: Signal “pops” during recording
When using inter iOS apps with midi in Auriapro use only 44.1 khz and 512k buffer size as your lowest buffer size. Make sure your audio interface is locking in at 44.1khz. And finally if your runnng intense cpu apps and any of Aurias plugins than you may be getting a memory under run. Reboot your iPad to clearly remove any background memory used and turn off wifi and bluetooth if your not using it. Cheers.
Who is online
Users browsing this forum: No registered users and 393 guests